2013 BEST PRICE Waste Tire Recycling Production

الوصف

The tire crushing line can crushing the whole tire into the powder or the grain.It consisted of steel puller,tire cutter,tire shredder,coarse crush,fine grinder fibre separator and so on.Every line depends the capacity pe year want to reach,the material of the tire and crushing fineness of finished materials output.The recycling line how to move.Fist we can use the tire wire drawer to remove out the steel wires from the tires.Second cut the tire into blocks/strips.(If the tire's diameter less than ***0mm ,we can remove these two process).Sencond we use the belt conveyor to convey the tire's blocks/strips in the tire shredder,and to break up it into **8cm block.Third we use the belt conveyor to convey the tire's blocks in the two roller rubber crusher,and to break up it into ****0 mesh and also it can separate the steel.Fourth,the RX***0Rubber Powder Screener can screen the qualified powder into the nest process,the coarse powder break up again.Fifth ,DCT***0 Belt Mode Removing Iron Machine and ZY-CX*0Magnetic Seperator to seperate the steel cleanly.And use Piple Conveter convey material in the fibre Separator is used in separating the fine fluff fibre mixed in rubber poeder which is crushed,to improve the purity rubber powder and the quality of product.

Summary:

1.To granulate radial tires into fine rubber crumb of 5~**0 mesh with steel and fiber completely recycled at ambient temperature.

2.The is whole tires,after the processing,steel is completely separated and fiber can be separated up to *5% or above.The finish product is high and competitive in the market

3.Tight construction, small space and simple technique flow.

4. Low energy-consuming and good performance-cost ratio

5.Hight automatization, fewer labors requirement.

6.Reasonable construction,easy operation and low rate of breakdown

7.Environmental-protection,no pollution(no waste gas,no waste residue,no polluted water),meeting the environmental requirement of the government.

Main Process:

1.steel wire drawer: separate the wire in the tyre.

2.whole tyre crusher: crush the tyre to ****0cm chips

3.rubbing/cutting machine: coarse crushing, fine milling, separating steel wire etc .

4.rubber powder screener: grading the crude fibre and rubber powder.

5.Belt Iron separator: mainly applied for separating the iron materials from the rubber particles.

6.Magnetic roller Iron separator: can be effectively used for separating small iron powder.

7.rubber fiber separator: used in separating the fine fluff fibre mixed in rubber powder.

8. rubber fine miller: fine grind the rubber granule to ****0mesh.

Technology Process:

Service: One year guarantee and lifelong maintenance.Any problem,you could contact with us,we will feed back you with *4 hours.

Remarks :The quality guarantee is *2 months after finishing the trial run of machines which has been shipped to the buyer side. If any part (excluding easily damaging parts) is found defective in quality within warranty period, we would like to replace it for free. After warranty, spare parts can be replaced based on favorable price.

 The tire crushing line can crushing the whole tire into the powder or the grain.It consisted of steel puller,tire cutter,tire shredder,coarse crush,fine grinder and so on.Every line depends the capacity pe year want to reach,the material of the tire and crushing fineness of the finished materials output.