الوصف

B**3,B**4,B**5,B**6,B**7,B**8,B**9,B**0,B**1,B**2,B**3,B**4

 

Type B**0(S**0) is a non bearing supported sprag type freewheel. Including: S**3(B**3) S**4(B**4) S**5(B**5) S**6(B**6) S**7(B**7) S**8(S**8) S**9(B**9) S**0(B**0). The sprags run directly on the shaft provided by the user. Bearings are required to support axial and radial loads. Lubrication and sealing must also be provided by the installation.

The housing bore to receive the outer race will be machined with a H7 tolerance.

A key will transmit the torque. The shaft on which the sprags run must have a surface hardness of HRC *0 to *2 for a finished depth of 0, 6 mm minimum. Core hardness should be HRC *5 to *5. Surface roughness must not exceed *2 CLA.



Maximum shaft taper 0, *1 mm per *0mm length. Concentricity between shaft and housing bore should be maintained within TIR 0, *5 mm. The preferred lubrication is oil. The design allows the use of most of the common lubricants used in power transmission including gear oils with EP additives.



When necessary grease lubrication is also possible.