الوصف

First of all, a hole is punched through the partition in such a way that it gives the way to the connecting path of two cells through the partition of the container. The size of the hole is very crucial because the cross section of the hole will determine quantity of current to pass through as Cross-Section of any conductor decides the flow of current depending upon its resistivity. This Diameter of the hole will vary depending upon the Discharge Rate of the Battery (Capacity of the Battery). Hole should be sharp cut without Burrs & the Center distance of the hole from the partition & Bottom should be accurate. One hole can be punched in one go where lesser quantity of the Battery Production is required provided container is placed properly. Operator has to place the container in the up side down position CAUTIOUSLY container has to be placed properly so it fits into position made for it and pressed firmly every time to get hole at the same height. If it is not pressed properly then every time hole height will vary, which will show its faulty results in partition cell welding. By neglecting this operation to a lesser importance will be fatal to the Battery. This hole is the foundation for the Heat Sealed Battery. Check all five holes punched without any extra material left.