Car driving simulators

الوصف

Detailed specifications:

1,Cockpit from the cockpit seat, visual computer screen (monitor), operating sensors, data acquisition card, headphones and other components.

Cockpit control system contains five: the steering wheel, clutch, foot brake, throttle and handbrake.

The car stalls contains: reverse, a, second, third, fifth and four gear, neutral (automatic block contains only forward, reverse and Park)

Operation: the left turn light switch, the right steering lamp, horn, ignition switch, electric switch, safety belt, door, windshield wipers, headlamp, headlight.

Different participants operating member by operating through the respective different operating signals generated by the sensor. The operation signal is sent through the data acquisition card to the computer, through a variety of training models realistic operation, finally the screen corresponding to the operation on the output measurements of the scenes and sounds.

2.specification

Length: ***0MM

Width: **0MM

High: ***0MM

3. the shell's structure

High precision density board elegant packaging

4. the work of power

Single AC**0V ± *0%Hz; the consumption of apparent power: ≤ 1KVA

5. The main interface

The main interface using three-dimensional animation , click the will change to red.

5.1 Weather training

The system simulation training in addition to sunny weather, also can simulate the "Snow", "rainy day", "fog" all kinds of different weather, to improve the students ability to adapt.

5.2 *2 kinds of training models

The system provides a "manual" car "manual" Jeep "manual" truck "manual" bus "automatic car" and "automatic Jeep" and other *2 kinds of training models of the simulated driving.

5.3 Place driver training

In situ driving training for students is mainly used for the early shift training, to enable students to replace the stalls and trample clutch moves more coordination, avoid taking down shift form bad habits.

5.4 Driving venue

Ground driving venues including nine test items and reverse parking, all examination in strict accordance with the formal examination standard.

Site training, if the examination failed, then the system will automatically return to the starting position of the vehicle, convenient for students to train or test.

5.5 Reversing storage

Reversing storage driver examination in the assessment of a point, that is in motion control vehicle from both sides right into the garage.

5.6 Parallel parking

"Parallel parking" allows the driver to control the vehicle properly parked on the right road parking (garage) the skills to adapt to life in the temporary parking daily driving needs. Drivers driving without grazing location stakes, the wheels do not touch the lane edge pressure, location sideline case, by a further retreat, the right side of the vehicle into the garage bits.

5.7 Parking ramp and start

Assessment vehicle driver driving a vehicle on the ramp skills and accurately determine the location of the vehicle, the proper use of the brake, gear and clutch to fit in with the start uphill parking needs. Assessment uphill driving a vehicle driver's ability, the correct vehicle parked aside a fixed location's ability to accurately apply the clutch gear and the ability to adapt to the uphill road waiting for the release operation when needed. Motor vehicle drivers through visual and sensory timely manner to determine the size of the slope of the ramp, the length of road conditions and road width, etc., take the right methods of operation, smooth stop and start control of the vehicle. Do turn right, shift quickly, manipulating the accelerator pedal, the parking brake and clutch pedal action and accurate coordination. Judgment and prompt: "sentinel parking and ramp start" examinations, "sentinel parking and ramp start" end of the examination, the vehicle stopped, the front bumper strongyloidiasis more than *0 cm from the pile, the pile did not stop the vehicle bumper pole line, after more than *0 cm, not more than *0 cm, the vehicle stops, the vehicle body from the road edge line of more than *0 cm, the initial hours after the slip is greater than *0 cm, slip less than *0 hours after the start centimeters.

5.8 Curve driving

Assessment driver of the vehicle and the direction of the use of running track master. Motor vehicle driver driving the vehicle forward into the terminal from the corners, slow shift to withstand low exit from the other end. Not moving rolling curve edge line, steering freely. Judgment and prompt are: "curve driving" examinations, "curve with" end of the examination, the edge of the wheel pulled out of line, the wheel pressure road edge line, halfway to adjust body position.

5.9 Right-angled bend

Rapid assessment of the use of the driver sharp turn direction road vehicle wheel gaps correct judgment. Motor vehicle driver driving the vehicle at low speed according to the provisions of the line, from left to right or from right to left right angle turns, once passed, can not stop halfway.

Judgment and prompt with; "quarter turn" examinations, "right-angle turn" end of the examination, the wheels touch the salient points or exit rolled edge line, halfway to adjust body position, the wheels touch the rolling road edge line, with the reverse finish.

5.*0 Comprehensive training

Comprehensive training, set up a "City Road", "highway", "country roads" training scenes. In each training scenario, and set up a variety of dangerous situations, such as pedestrians crossing the road, pedestrians slide, crosswind.

Comprehensive training, in strict accordance with the Ministry of public security three test subjects for discrimination and tips.

5.*1 City road

City road scene set in the overpass, crossroads, T-junction, annular island ring road, tunnel, etc.

5.*2 highway

A toll station, the overtaking lane, lane, export traffic sign training scene.

Training content: distance to confirm, tunnel driving, highway entrances and exits

5.*3 Rural road, mountain road

The sharp, steep, muddy road, road and other training scene immersion.

5.*4 theoretical knowledge

***3 January the latest drive r theory test system (motor vehicle driver examination subject) a total of **0 points, students assessment of *0 points and *0 points above that clearance. The examination time for *5 minutes, small cars, vans all models for the single problem, to determine the problem, no more questions and animation. Since January 1, ***3, the provinces are increasing subjects four safe and civilized knowledge test content, test questions for the ***3 questions, including *2 multiple choice and *2 animation problem, apply to the C1 C2 B1 B2 A1 all models!

5.*5 The sensor data set

Turn the steering wheel to the left in the end portion, and then mouse click on the red "Record" font settings.

Turn the steering wheel to the right in the end portion, and then mouse click on the red "Record" font settings.

Loosen the clutch in a natural state click on the red "Record" font settings.

Ministry clutch stampede in the end click on the "record" font settings.

(Other operating ibid.)

7. forthputting

The main interface

Start by Key

Note: After an attachment, USB extension cable one.