The materials of copper mould plates should be the ones with good tensile strength, fatigue strength, proper hardness, low elongation and high heat conductivity coefficient. As a result, material like CUAG，CR-ZR-CU are widely accepted by users of all countries.



Coatings:

Copper has lower hardness which leads to lower anti-abrasive property. Therefore, the area at the lower part of the moulds, where the stress increases drastically due to shells, will be more severely worn. To increase the life time of copper moulds, Uniform mould interior surface plating with suitable hardness is needed. Most of the copper mould tubes for small size billet casting are not used in any casting system where there are rigid casting stream support, therefore they are very sensitiveto be worn. We use hard chrome plating to increase the life of mould tubes. The plating thickness will be controlled in the best range. As for the coating of copper mould plates,based on our years of experience, we are able to provide Cr coating, Ni-Cr coating, Ni-Fe coating and Ni-Cr coating to meet the demand of various customers both at home and abroad.



 

Notice:

 

1. Please use the copper mould plate within one year.

2. Please store the copper mould plate in someplace dry and well ventilated

3. Keep the copper mould plate away from acidic materials, especially the internal coating surface.

4. Polish the external surface of the copper mouldplatewith sand paper if oxidized.

5. Pouring the molten steel to the center of the copper mouldplate

6. Avoid internal surface scratch of the moulds caused by manual operation.