Shaping machine

الوصف

Molding machines, also known as out of the box machine is automatically out of the box, forming, bending under the bottom hinge. And now to complete the next part of the taped, will mount into open cardboard box board, according to certain procedures equivalent to the bottom of the box, and sealed with tape transport to the packing machine of special equipment. Automatic carton forming machine, automatic high-volume carton box machine is automatically out of the box, under the cover automatically converted, self-sealing tape under the bottom of the line equipment, machines used in all PLC + display control, greatly facilitate the operation, the scale of production will be automated essential equipment.


Machine characteristics
 
molding machine adopts imported PLC mainframe computer chips, matching LCD display, backup software malfunction self-diagnostic system and error correction features that make operation more convenient, the design control procedures in order to fool without professional training to operate induction .

molding machine hydraulic drive, hydraulic stepless has pioneered FM technology to solve a variety of materials, machine and block-type fitness, increase the density of the material, shortening the molding cycle.

 to use Machine
 
1, choose the flat table, put stable machine, pull the foot box can be easy to observe the machine panel.
2, the hand-held sensor head plugs into the socket on the panel and tighten. Note positioning gap
3, one end of the power cord socket on the rear panel into the chassis, the other end into a power supply outlet, be sure to use the single-phase three-wire power supply.
4, open the case after the board of the "power switch (POWER SW.)", According to panel "power switch (SWITCHING)" , to be "ready (WARM UP)" green light, the machine can work.
5, hold down the "set (SETTING BUTTON)" , set to appropriate values​​, generally between 0.**2.0 seconds.
6, the sensor head on the container lid above, click the start on the handle, then the "heating (HEATING)" red light, that is heating, do not remove the sensor head, "heating (HEATING)" red light off and then remove the sensor head, and other "ready (WARM UP)" green light or buzzer inside the short sound "beep" prompt and then the container can be sealed next job.
7, check the seal of quality, depending on the material, the diameter of the container and the production efficiency, proper trimming "setting (SETTING BUTTON) key to make the best sealing quality.

Machine works
 
Machine works with an injection with a syringe similar, it is with the screw (or plunger) of thrust, will have a good molten plastics (ie, viscous flow) closed well into the plastic injection mold cavity, the products obtained after curing shaping process.
Injection molding is a cyclic process, with each cycle including: dosing - molten plastics - pressure injection - filling the cooling - Kai-mode pickup. Remove the plastic parts and then re-closed mode, the next cycle.

Machine technical parameters
 
Lack of tape and cardboard boxes automatically when the alarm