Single Vertical Flame Spread Tester/Single Cable Burning Testing

الوصف

Introduction:
Single wire and cable vertical burning tester is themost widely used and low cost of cable fire performance test equipment; TESTECHsingle wire or cable burning tester meet the national standard GB /T****0.******8 / IEC********1: ***4 requiremen. It is to test cable , flameretardant insulation layer under fire conditions applicable for testing wireand cable in overheating, overcurrent and other non-normal state. It can beused in vertical or fiber optic wire and cable flame spread test, while testunder fire conditions Dettol matter combustion conditions.

International standards:
 

IEC ********1,2,3
EN ***********4
GBT ****0.*1,******8 
Features:

1, the touch screen intelligent control system; English user interface;

2, the system automatic ignition, automatic timing, automatic datastorage;

3, the test section and the control section is conbined design in onebox for operation;

4, stainless steel test box, the internal cavity size: height ***0mm,width **0mm, depth of **0mm;

6, a pre-mixed burner, an inner diameter of ¢ *2 ± 0.5mm, length is **0mm. 1KW hybrid standard burner,which provides accurate test fire source;

7, the flame burning applied time and hold time can range from 0 to *9 minutes*9 seconds range adjustment. Automatic control of the testing process.

8, import needle vavle precisely adjust the flame height, according tostandards, thef blue flame height is *0mm ~ *0mm, total height **0mm ~ **0mm

9, the gas flow rate is controlled by needle valve

*0, equipped with a steeless flame height caliper.

Specifiction: