Sleeve anchor with hex bolt carbon steel

الوصف

Sleeve Anchors With Anti-Spin For Heavy-Duty Fixings. Hexagon Bolt type.

Before placing the anchor checks to be made to ensure the strength class of the
concrete is not lower than that to which the characteristic loads apply
• The concrete to be well compacted, e.g. without significant voids
• Base material temperatures during installation: *5 / + *0 ºC (*0 ºC in a short
period of time)
• Anchors to be installed ensuring not  less than the specified embedment depth,
The edge distance and spacing to be kept to the specified values, no minus
tolerances to be allowed
• Drill to the minimum depth and diameter specified, maintaining perpendicular to
the surface of the base material. Fixture holes themselves can be used as
template. 
• When drilling holes, care to be taken  not to damage reinforcement in close
proximity to the hole position. Action to be taken in the event that drilling is
aborted, e.g. due to encountering reinforcement. It is recommended to either
install the anchors immediately beside  the aborted drill hole, provide that
anchoring depth is increased by the depth of the aborted  drill hole, or make a
new drilling at a minimum distance away of two the depth of the aborted hole.
Alternatively, a smaller distance may be chosen, provided the aborted drill hole is
filled with high strength mortar. However, unless the aborted drill hole is filled
with mortar, it is not permissible a shear or oblique tension load in the direction of
the aborted hole.
• Thoroughly clean hole from dust and drilling fragments.
• For holes to be subjected to temperatures below 0 ºC, measures to be taken to
avoid the ingress of water into the hole and subsequent risk of local cracking of
the concrete due to ice expansion.
• To introduce the anchor into the hole  up to the embedment depth through the
fixture, a hammer can be use to assure this depth. Do not apply any intermediate
lay between the fixture and the washer (sealant, etc.). Apply the specified torque
with a torque wrench.
• In case of holes with diameters higher  than specified, use  washers of bigger
diameter and thickness, but in this case it is not assured a correct distribution of
shear loads amongst all the anchors of a same group. The shear load will be
applied on those anchors with the correct diameter on the fixture.

بلد:	China
نموذج رقم:	CH
سعر فوب:	(قابل للتفاوض) أحصل على آخر سعر
الموقع:	cixi of Ningbo
سعر الحد الأدنى للطلب:	-
الحد الأدني للطلب:	1 Pallet
تفاصيل التغليف:	boxes then cartons, on pallets
موعد التسليم:	2-3 months/plt
القدرة على التوريد:	100000000 Piece per Month
نوع الدفع:	T/T, L/C
مجموعة المنتج :	sleeve anchor