الوصف

CM series controller is a kind of intelligent, multi-purpose solar charge and discharge controller. The family use the fixed LCD display, with a very friendly interface; various control parameters can be flexibly set, fully meet your various application requirements. CM series controller has following features: Image of LCD graphic symbol Simple operation Automatic Identification System Voltage level Intelligent PWM charge mode Automatic Temperature Compensation Adjustable charge-discharge control parameters Settable Operating mode of Load Overload, Short Circuit Protection Remote monitoring and control function (custom) Battery reverse-discharge protection Battery Low Voltage Disconnection (LVD) Battery reverses connection protection Accumulated function of charge and discharge Ampere hours 2. Installation Install： â‘ Ready tools and cables. Encourage you to matching the right cables. Ensure that the current density ＜4mm² that is conductive to reducing the line voltage drop. Recommended: *0A with *0mm² cable. Check weather the installation sites compliance with the relevant safety requirements. Please avoid the damp, dusty, there is a place flammable, explosive and corrosive gases use the controller to install. â‘¡Install the controller into a fixed vertical plane. See section 5 of the pore size and pore spacing. In order to ensure a good thermal control conditions, please set aside each *0cm below the controller space. â‘¢As shown on the right, connect the (1) Load, (2) Battery and (3) Solar Panel to the controller according to the order of (1) (2) (3). Pay attention to the load, battery, solar panel and controller of same polarity. â‘£Put into the external temperature sensor on the left of the controller (probe port). The temperature sensor should be similar space with battery. (Otherwise, the controller will control the parameters of all wrong temperature compensation.)