الوصف

Heating And Pumping  Unit :

Thermal Heating and Pumping Units are Pre- Engineered and compact. They are designed to supply fuel Oil to Clients Installation at a predetermined constant temperature and pressure required for efficient combustion.

          Fuel  Oil at Pumping viscosity from the plant to oil supply line enters this unit which automatically heats and re – circulates the oil to maintain it at the higher temperature required for good burner operation and combustion.

Different Models:

The Heating and Pumping Units are supplied in the following three Models:

1.   Simplex Model – SPH :

This essentially consists of 1 no. Motorised rotary gear Oil Pump and 1 No. Preheater.

2.   Duple Model – DPH - I:

This model is supplied with 2 Nos. Motorised rotary gear oil Pump and 1 No. Preheater. One of the pumps is for actual operation and the other is to act as a stand bye or for alternate use.

3.   Duplex Model – DPDH - II :

This  model has two pumps with motors and two preheaters. While one set of pump and pre heater is operating the other set acts as a stand bye or for alternate use. The filters with model as well as the other models may either be Simplex or Duplex Type.

Capacities :

Thermal Lining Pumping and Heating Units are supplied in various capacities depending on the amount of oil they have to pump and preheat. Generally the capacity of the Unit is expressed in terms of the kilowatt rating of the electric oil Preheater which again determines the maximum amount of oil the unit can preheat over a given range of temperature. Following  table gives the maximum about of oil which can be heated by a unit of a particular size.