Wide Base DIP switch

الوصف

Features:
1.All materials are UL *4VO grade,high temperature resistance plastic
2.Twin contact design to ensure stable contact.
3.Gold-plated contact to ensure low contact resistance.Tin plated terminals to prevent contamination during soldering.
 
Ratings:
Contact Rating
Switching         :*5mA at *4VDC
Non-Switching     :**0mA at *0VDC
 
Contact Resistance
Initial             : *0MΩMax
After life          :**0MΩMax
Insulation Resistance:**0MΩMin,*0sec at **0VDC
Dielectric Strength:**0VDC for *0 seconds
Switch Capacitance:5pF Max at 1 MHZ
Operation Temperature:**0℃~**5℃
Storage Temperature:**0℃~**5℃
 
Mechanical&Processing
Operation Force:***0gfMax
Mechanical Life :***0 cycles Operations
 
Switch Operation and Taping
1.Use Tweezer or ball point pen for operation
2.Flux cleaning should be done without removing the Tape.
3.If the Tape is removed,it adhered less than before when it is placed back on ,possibl causing flux inflow.
4.Do Not Remove Tape sealed before Reflow Processing.
5.Ultasonic cleaning not recommended without Tape sealesd
*Keep all actuators inOFFposition during soldering and cleaning process.
*Any flux enters the switch may influence contact function.
 
 
 
Environmental TEST
Cold Resistance Test
Switches under temperature at - *0℃ ±2℃for *6 hours
 
Dry Heat Resistance Test
Switches under temperature at *5℃ ±2℃for *6 hours.
Humidity Test
Per MIL-STD- **2F,Method **3B Test Condition B:
There shall be no evidence of corrosion and the insulation resistance shall be no less than **0   megaohms
 
Vibration Test：
Per MI-STD- **2F,Method**4 D，Test Condition A：
There shall be no opening of closed contacts or closing of open contacts in excess of *0  microseconds.
 
Shock Test:
Per MIL-STD- **2F,Method **3B ,Test Condition A:
There shall be no opening of closed contacts or closing of open contacts in excess of *0 microsecond.
 
Thermal Shock Test:
Per MIL-STD- **2F,Method **7G，Test Condition A:
There shall be no evidence of physical damage or permanent change in electrical characteristics .
 
Salt-Spray Test
Per MIL -STD - **2 F,Method **1D,Test Condition B :
There are under *5℃ ±2℃  in temperature and 5±1% salt-water concentration for *8±1   hour.