الوصف

withdrawal(Extraction) sleeves can be used to mount bearings with a tapered bore on cylindrical seats of stepped shafts. The sleeve is pressed into the bore of the bearing that abuts a shaft shoulder or similar fixed component. The sleeve is located on the shaft by a nut or an end plate. Lock nuts or endplates are not supplied with the withdrawal sleeves. KM or HM lock nuts and respective locking washers are suitable but must be ordered separately. Further information will be found in the section "Lock nuts with locking washer or clip". To secure the bearing to the shaft, press the withdrawal sleeve into the bearing bore. To do this, particularly where larger bearings are concerned, considerable force is required to overcome the friction between the mating surfaces of the bearing and sleeve and of the sleeve and shaft. Mounting and dismounting of bearings on withdrawal sleeves can be facilitated considerably by using a hydraulic nut . Basic design ADP withdrawal sleeves are slotted and have an external taper of 1:*2 except for those in the AH **0 and AH **1 series which have an external taper of 1:*0 and are intended for use with wide bearings in the *0 and *1 Dimension Series. The nuts required for dismounting the withdrawal sleeve are not supplied with the sleeve and must be ordered separately. Appropriate sizes are listed in the product table. Appropriate hydraulic nuts for dismounting are listed there as well. Materials The materials using in ADP withdrawal sleeves are carbon steel with a tensile strength at least **0N /mm2. Dimensions The dimensions of ADP withdrawal sleeves are in accordance with ISO *****1:***5. Tolerances The bore diameter of ADP withdrawal sleeves is to tolerance JS9, the width to h*3. Thread ADP withdrawal sleeves up to size *8 have metric threads with 6g tolerances according to ISO ****3:***8. Larger withdrawal sleeves have metric trapezoidal threads with 7e tolerance according to ISO ***3:***3.