الوصف

~DBW8N-wire control model instruction

 

Brief Instruction

The whole set firing system including one waterproof main controller, 8 pieces 8 channels receivers. It could run **0pcs receivers maximum. The DBW8N main machine is powered by 4 AA batteries. The main controller and receivers could connect by a common copper wire. It could do sequential and all fire from different receivers. Furthermore ,the sequential fire is including the along and inverse model. Time range is from 0.**9.9 seconds.

This model is perfect for the stage fireworks display. It could make all kinds of special effects on the stage. And the wire control model could avoid the problem of radio interference. It makes the display more stable and safe.

 

Operation    

1. Put the batteries into the controller and receivers separately. Turn on all the power switch. The indicate lamps get light.

2. Connecting the copper wire into the “signal output” of the controller and the “signal ” of the receiver .(the copper wire is no matter of length and positive/negative poles.) The quality of the connecting receivers is not limited by one wire. The receiver power lamp will get Green if the wire is connecting well.

3. First confirm the position of the receiver. Then adjust the District on receivers. Checking again if the receiver power lamp get green. If it get green means the controller and receiver connecting well  

4. Turn off the power on the receiver. Connecting the products into the black/red clips. After that, turn on the power again . If the indicate lamp go out, it means the products are connecting well.

 

Single model

1. Move the model to “single”

2. Select which receiver to do the single fire. Pressing the “+””-”s on the controller to select the receivers. Please adjust the receivers district by the same manner. If the district on the main controller is 5, it means the controller will fire the receivers 5.

3. Pressing any channel(**8) on the controller ,and then the corresponding receiver’s channel will fire.

4.Sequential fire: pressing the time”+””-” , the sequential time will add or reduce by 0.1 second. After adjust the need time, pressing the “rapid” then fire sequentially. If pressing the “All” , the 8 channels will fire together.

 

Online model

1.First move to the “online” model.

2.Adjust the receiver’s quality for online model. Pressing the “+””-” on the controller to set up quality of receivers. For example, using 8 receivers to do the online model. First adjust the controller to 8, and then adjust the first receiver to 1,second to 2…the eighth receiver to 8.                                            

 

A-All fire function

Move to “All” position. And then press any channel among 1 to 8. Then the correspondence channel on the online receives will fire together.

Sequential fire function

Move the controller to the “rapid” position.

 

B-Toward a rapid fire. Move the “online function” to “along” position. Pressing the “+””-”to adjust the sequential time. After that, press any channel among **8. And then that channel on all online receivers will fire sequentially. (fire from **8)

 

C-Reverse a rapid-fire. Move the “online function” to the “inverse” position, and then adjust the sequential time. After that, pressing any channel from **8,the channel on all the receivers will do the inverse sequential fire (fire from **1)

 

Parameters of the main controller

1.weight:1.5Kg             2.dimensions: *5**7**2CM