Bobby hairpins making machine, Mode No 230/2 50 The machine works fully automatic. Half round as well as fiat wire is used from wire coil.The roller device in front makes the wire pass through correctly. The adjoining pulling in device pulls the wire into the machine. After having been pulled in the wire is waved. For this act the corresponding waving tools are to be used. After having been waved the wire is carried on and cut to length. Now the wires haft is seized and bent by the pliers and the finished bobby hairpin leaves the machine. AH movements are positive and thus guarantee wefl4ormed pins of always the same length. Un a hardening furnace the pins are put under the wanted temperature and thus spanned. After cooling off they are paced into a shaking barrel where the wanted varnish is added. When using calcination varnish the pins are again paced into a Furnace where the varnish is calcined. When using air drying varnish the pins are placed upon a sieve and lft to dry. When imitating celuoid, the grips are hardened, brass plated and after sprayed by means of a stencil