الوصف

Generator Controller Diesel Generator Controller HGM**0HC is an Automatic Engine Control Module. The module is used to automatically start and stop the engine, indicating the operational status and fault conditions, automatically shutting down the engine and indicating the engine failure by LED on the front panel. HGM**0HC append a LCD hours count that base on HGM**0. Low Oil Pressure High Engine Temperature Auxiliary Shutdown Over speed This will remove the fuel supply from the engine and bring it to rest. Each alarm has its own LED indicator and once activated no further alarm conditions will be accepted. The alarm output and relevant LED will remain active until the unit is reset by turning the switch to the ‘O’ position. Over speed Protection Over speed protection is derived from magnetic pickup sensor. Over **4% of rated speed will shutdown the engine. During engine cranking and for a short time afterwards the protection hold-off timer (*0 seconds) is active and the relevant alarm s are inhibited. This enables the engine to start and achieve normal running conditions. Once the timer has expired the s are enabled providing normal protection from the module. Charge Failure warning Charge Failure warning is also provided by monitoring the WL terminal on the charge alternator. This operates on a similar principal to the warning lamp fitted in a motor vehicle, should the output fail the charge fail LED will illuminate. The module will also provide the alternator excitation current via this connection. SPECIFICATION DC Supply: 8 to *5 V Continuous. Speed Sensor Input Range: 1 – *0V(p-p) Speed Sensor Input Frequency: **0Hz **0KHz. Start Output: Relay *6 Amp DC at supply voltage. Fuel Output: Relay *6 Amp DC at supply voltage. Pre-heat Output: Relay *6 Amp DC at supply voltage. Stop Output: Relay *6 Amp DC at supply voltage. Configure Output: Relay *6 Amp DC at supply voltage.