الوصف

generator controller genset controller HGM***0K HGM***0K/***0KC: Automatic Start Module, it controls generator to start/stop by remote start signal; Using microprocessor as a core, graphics LCD with big screen and backlight, display between Chinese, English, and Spanish, key touch for operation; Have a RS**5 port, can used for communicate with PC; Measure and display 3 phase voltage, 3 phase current, frequency, power etc. parameter; Mains have over voltage, under voltage, loss phase function; Generators have over voltage, under voltage, over frequency, under frequency, over current function; Power on mode can select: Shutdown mode, Manual mode, Automatic mode; Double temperature double oil pressure sensor ; Control protection: Automatic start/stop, load transfer and alarming of generator; With ETS solenoid hold, idle control, pre-heat control, raise speed control function, and equal to relay output; Controllers have the historical records, real-time clock, and scheduler run (PC) function. Parameters setting: Allow user to modify setting and store them inside internal FLASH memory, the parameters can not be lost even with power down. Most of parameters can be set from the front panel, or be set by PC used SG*2; Three channel analog s, may joint with Resistive-type temperature/ pressure/ fuel level sensors, several temperature and pressure sensors can be used directly (ie. VDO, DATCON, CUMMINS), also may select “user defined” sensor via entering 8 point curves; Display of generator cumulated electric energy; Security password-protected programming levels; Several crank success conditions are optional; Built-in speed/frequency detecting units can accurately judge the states such as crank success and over speed; Power supply range is wide, accommodating to different starting battery voltage environments; All parameters use digital modulation.