Description

We are biggest manufacture of casting powder in Aisa area as well as worldwide. Our product has export to many countries.
Continuous casting mold powder is an important product which should be not only of good properties, but also should be used in correct way. Otherwise the performance will be bad, and even may result in many defects both in surface and inside of the Beam Blank. So it is very important to use the Casting Powder in correct way.
1. The thickness of Casting Powder should be *0~*0mm in the the copper mold, and the powder slag layer must be thick enough so that the powder will melt evenly in the the copper mold, and keep liquid slag layer stable, as well as thermal insulating.
2. Operator should add Casting Powder into the the copper mold evenly, the time interval of adding Casting Powder should be proper, the principle is to add a small amount each time but keep on adding operation consistent, so that the surface is always black instead of red.
3. During normal casting, it is forbidden to stir the surface of liquid steel in the copper mold. If small slag rings appear on the side wall of the copper mold and don't go on growing bigger, no need to stir and pick them out frequently. When the surface of liquid steel fluctuating, it's normal that the slag appear on the wide wall of the copper mold and no need to pick out.
We can supply
Continuous casting mold powder for stainless steel bloom
Continuous Casting Mold Powder for Bloom and Rectangle Billets
Continuous Casting Mold Powder for Beam blank
Continuous Casting Mold Powder for High Carbon Steel Slab
Continuous Casting Mold Powder for Round Billets
Csp continuous casting mould powder
Continous Casting Starting Powder
Special xxxxx Mold Powder for Ultra Low Carbon Steels
xxxxx Mould Powder for Medium Carbon Steel Slabs
xxxxx Mould Powder Billets
xxxxx Mold Powder for low Carbon Steels Slabs
My mail: *@********************ml>