Description

Main Structures and Technical Parameters 1、Reed width: ***0mm, ***0mm. 2、Beating-up: crankshaft weft beating. 3、Weft insertion: double-rapier weft insertion. 4、Overlocking: independent hook needle overlocking mechanism. 5、Weft feeding: tension compensating mechanism. 6、Let-off: four rubber-covered rollers are tightly grasped with steel roller; positive speed-adjusting continuous let-off. 7、Shedding: single dobby mechanism, conjugate cam positive driving, dobby shedding is controlled by pattern paper and peg, *6 heald frames. 8、Take-up: ratchet type pin-roller intermittent take-up. 9、Warp supplying: creel-type continuous warp supplying without yarn tail. *0、Driving: The driving system consists of motor, band pulley and gear, etc. Main drive motor: 4KWï&frac*4;Œ**0rpm (Model **0)ï&frac*4;›5.5KWï&frac*4;Œ**0rpm (Model **5). *1、Loom speed: ****0rpm (frequency stepless regulating speed). *2、The electric part has the fuction of starting, dot motion, rapid stopping, etc. *3、Overall dimension (not including creel) (length×width×height) (mm): ***0×***0×***0 ( Model **0); ***0×***0×***0 ( Model **5). *4、Weight: about 5T