Description

Theï¿&frac*2;AQ***0 OTDR comes in eleven models combining different measurement wavelengths and dynamic ranges. Supported wavelengths: ***0, ***0, ***0, ***5, ***0 nm (single mode), **0, and ***0 nm (multi mode).ï¿&frac*2;On-site test time isï¿&frac*2;condensed with this OTDR - The time to power up the device, the time taken to make measurements, and the time to analyze and store the measurement results are reduced significantly. The measurement results can easily be transmitted to computers using the USB interface or the Ethernet and the analysis software (optional) helps with preparation of computer generated reports. Please advise the specific AQ***0 you need as based on your testing requirements: *****0 ***0nm SMF *2dB ***0nm model for access networks and FTTH *****1 ***0nm SMF *0dB ***0nm model for maintenance of access networks and FTTH *****2 ***0/***0nm SMF *4/*2dB For installationc and maintenance of access networks and FTTH *****3 ***0/***0nm SMF, Hi-DR *0/*8dB High dynamic range model for installationc and maintenance of metro networks and access networks *****4 ***0/***5nm SMF, Hi-DR *8/*5dB High dymicrange model, supporting maintainance wavelength ***5nm *****5 ***0/***0/***0nm SMF *4/*0/*2dB Three-wavelength model for installation and maintenance of PON systems, supporting ***0nm *****6 ***0/***0/***5nm SMF *4/*2/*8dB Three-wavelength model, supporting a maintainance wavelength of ***5nm wavelengths *****7 ***0/***0/***0nm SMF *4/*2/*0dB Three-wavelength, supporting a maintainance wavelength of ***0nm *****8 ***0/***0/***5nm SMF, Hi-DR *0/*8/*5dB Three-wavelength, high dymicrange model, supporting a maintainance wavelength of ***5nm *****9 **0/***0nm MMF *2.5/*4dB Multimode fiber model for LAN maintenance *****0 **0/***0nm MMF ***0/***0nm SMF *2.5/*4dB *4/*2dB Four-wavelength model for installation and maintenance of LAN and FTTH with support for both multimode and single mode fiber.