Description

Speciications Model FSM**0S Fusion Splicer Applicable Fibers Single-mode (ITU-T G.**2), Multimode (ITU-T G.**1), DS (ITU -T G.**3), NZDS (ITU-T G.**5) Cladding Diameter *0Î&frac*4;m to**0Î&frac*4;m Coating Diameter **0Î&frac*4;m to 1, **0Î&frac*4;m Fiber Cleave Length 8 to *6mm with **0Î&frac*4;m coating diameter, *6mm with **0Î&frac*4;m coating diameter Typical Average Splice Loss 0.*2dB with SM, 0.*1dB with MM, 0.*4dB with DS, 0.*4dB with NZDS Measured by cut-back method relevant to ITU-T and IEC standards Splicing Time Typical 9 seconds with standard single-mode fiber Arc Calibration Method Automatic, real-time and by using results of previous splice when in AUTO mode, manual arc calibration function available Splicing Modes **0 preset and user programmable modes Splice Loss Estimate Based upon dual camera core alignment data Storage of Splice Result Last ***0 results to be stored in the internal memory Fiber Display X or Y, or both X and Y simultaneously. Front or rear monitor display options with automated image orientation magniication **0X for single X or Y view, or **7X for X and Y view Viewing Method Dual cameras with 4.1 inch TFT color LCD monitor Operating Condition 0 to 5, **0m above sea level, 0 to *5%RH and **0 to *0°C respectively Mechanical Proof Test 1.*6 to 2.*5N Tube Heater Built-in tube heater with *0 heating modes; auto-start function Tube Heating Time Typical *0 seconds with FP**3 sleeve, *5 seconds with FP3 (*0), ****5 seconds with Fujikura micro sleeves Protection Sleeve Length *0mm, *0mm, micro Splice/Heat Cycles with Battery Typical **0 cycles with power save functions activated Power Supply Auto voltage selection from **0 to **0V AC or *0 to *5V DC with ADC**1, *3.2V DC with BTR**8 battery Terminals USB 1.1 (USB-B type) for PC communication. Mini-DIN (*-pin) for HJS**2/*3 and SH*8 tube heater Wind Protection Maximum wind velocity of *5m/s. (*4 mph) Dimensions **6W x **1D x **3H (mm) / 5.3W x 6.3D x 5.6H (inches) Weight 2.3 kg (5.1 lbs