Description

OBD2 & EOBD Scanner. MS **9 Scanner supports all 9 OBD2 Test Modes on OBD2 compliant vehicles. Works on all ***6 and later OBD2 compliant U.S EUROPEAN & ASIAN Vehicles. Works on Falcon ***4 and later. Works on Commodore with GEN3 engine from ***1. & v6 from ***4. Determines the cause of the "CHECK ENGINE" light. Retrieves generic {PO, P2, P3 and UO}. and manufacturer specific {P1, P3 and U1}codes. Turns off "CHECK ENGINE" light. clears codes and resets Monitors. Displays DTC definitions on screen. Views FREEZE FRAME data. Displays Monitor and I/M Readiness Status. {emissions}. Identifies Pending codes. READS LIVE PCM DATA STREAM. Displays LIVE O2 Sensor test data. GRAPHS DATA ***6 and newer. Reads, stores and plays back live Sensor data. Memory / Battery backup for off vehicle data review and analysis. Performs Modules Present Test. Retrieves Vehicle Information {VIN CID & CVN}. Supports CAN {Controller Area Network} and other current OBD2 protocols. Built in OBD2 Look-up Library. Large easy to read backlit LCD screen. Software upgradeable via Internet. PRINTS DATA via PC. Comes with users manual, 6ft OBD2 cable, CD with DTC definitions and users manual. 9 volt battery, nylon carry case. VEHICLES COVERED. Holden Imported Commodore Range GEN 3 Commodore Range V6 Ford Imported Falcon Range V8 - L6 ***0 - ***8 ***5 - ***8 ***5 - ***8 ***0 - ***8 ***5 - ***8 BMW CHRYSLER DAEWOO DIAHATSU HONDA HYUNDAI JAGUAR JEEP KIA ROVER SERIES LEXUS MITSUBISHI MAZDA MERCEDES NISSAN PEUGEOT SAAB SUBARU TOYOTA VOLVO VW