Sell DP-810

Description

PHYSICAL PROPERTIES BEFORE CURE: Appearance Resin: Off-White Activator: Blue Chemical base Modified Methacrylic Resin Specific Gravity ( g/cm3) Resin: 0.*6 Activator: 1.*7 Flash Point (âï¿&frac*2;ï¿&frac*2;), TCC &*;&*;&*;&*;&*;&*;&*;* *@********************ml;¿&frac*2;ï¿&frac*2;, CPs Resin: **0, **0 cp ±5, **0 Activator: *5, **0 cp ±5, **0 Mix Ratio *0:1 (By Volume) CURE CHARACTERISTIC: Cure Condition Room Temperature Cure Working Time 5~8 min Fixture Time *5~*0 min Operating Temp. **5âï¿&frac*2;ï¿&frac*2;~ **0âï¿&frac*2;ï¿&frac*2; Gap Filling 0.5~1.0mm Gravity (After Cured) 0.*7 MECHANICAL PROPERTIES AFTER CURED: Tensile Strength, psi 3, **0~3, **0 Tensild Modulus, psi *5, **0~**0, **0 Elongation at Break, % ïÂ&frac*4;ï¿&frac*2;**0 Shear Strength, psl 1, **0~2, **0 (gap 0.5mm) RECOMMENDED SUBSTRATE FOR BONDING: ABS STEEL, CARBON PVC ACRYLICS POLYESTER STYRENICS FRP GELCOATS URETHANES *STEEL, *STAINLESS ALUMINUM VINYL ESTERS *Primer may required HANDLING NOTICE: Application of adhesive at temperatures between *8âï¿&frac*2;ï¿&frac*2; and *6âï¿&frac*2;ï¿&frac*2; will ensure proper cure. Temperautures below *8âï¿&frac*2;ï¿&frac*2; will slow cure speed; above *6âï¿&frac*2;ï¿&frac*2; will increase cure ***** viscosities of Parts A and B of this adhesive are affected by temperature. To ensure consistent dispensing in meter-mix equipment, adhesive and activator temperatures should be held reasonably constant throughout the year.