Sell high/low density polyethylene

Description

CAS: ********4
HS Code: *******0
MF: CH2
Purity: *5%
Grade: Blow molding grade, injection molding grade, film grade, pipe extrusion grade, raffia grade
High-density polyethylene (HDPE) or polyethylene high-density (PEHD) is a polyethylene thermoplastic made from petroleum. It takes 1.*5 kilograms of petroleum (in terms of energy and raw materials) to make one kilogram of HDPE.
Application: Make barrela, plastic bottle and bag, make all kind of pipes, make shading net, and make cable wire-insulating.

Packing: *5kg/PP net bag, *2MT/*0FCL. Also meet your special requirements
CERTIFICATE OF ANALYSIS
Technical Data
High Density Polyethylene Extrusion ***0
Density g/cm3 **********0.**6
Melt Mass-Flow Rate (MFR) g/*0 min********0.*4
Elongation at Break % min**********0
Tensile Stress at Yield kg/cm***********0
Tensile Stress at Break kg/cm***********0
Tensile Strain at Break %**********0
Flexural Modulus kg/cm*************0
Durometer Hardness (D Scale, Compression Molded)*****4
Power ash%***********************0.*1

HDPE Blow Molding Grade
Property
Unit
Test method
Typical Value
Mass density
g/cm3
ASTM D****5
0.**5
Melt flow Rate(**0degree/2.*6kg)
G/*0min
ASTM D****8
0.*5
Tensile yield strength
MPa
ASTM D***8
*7
Flexural modulus
Mpa
ASTM *-* * *@********************M D***8