Introduction and
application
This is the device converting three phase power current into single
phase intermediate frequency current and enabling metal to produce
eddy current loss through electromagnetic field induction to
achieve heating and melting and is applicable to melting, heating
or holding of steel, copper, aluminum, zinc, tin, nickel silver and
other ferrous or nonferrous metal and alloy material, as well as
heating treatment prior to forging, sintering and tube-bending
forming in casting and melting industries.
Performance and
features
1. Zero-voltage
scanning soft start, start or stop at any time under any state
without impact on power supply;
2. Speedy melting, low production cost, low pollution,
conforming to environmental protection requirement;
3. Melting directly from low temperature, available
for fully emptying of solution, easy change of category of melting
material;
4. Flexibly adjustable power, easy and continuous
smooth adjustment, easily controllable temperature, low
oxidization loss, uniform metal content;
5. Furnace shell with cast aluminum ally or steel
shell construction, small footprint, easy overturn body, available
for selection of electric, manual, hydraulic or other overturn mode
as needed;
6. Contravariant automatic regulation circuit
available for matching of load impendence automatically,
maintaining good operation without regulation or compensation of
capacitance; power supply with fault diagnosis facilitating
service.
※ Melting time and power
consumption/ton is important to equipment power, raw material shape
and weight, operator’s skill level and other elements;
※ Power parameters shall be
subject to steel melting; lower power is required by melting of
copper, aluminum, zinc or other material with low melting point;
please consult Hengyang Technical Department for specific data;
※ Configuration: an intermediate
frequency power supply, a capacitor cabinet, an overturn control
cabinet, body, two sets of reduction boxes and supports, two water
cooling cables, etc.;
※ The above data is of standard
model. We also provide customized non-standard products with
different power or melting speed.
