Description
1.
INTRODUCTIONï¼›
Power Input
Voltage **0 ~ **0VAC
DC
Output
Voltage *3.8 VDC/Current 6A ~*0A
Voltage *7.6 VDC/Current 6A ~*0A
Voltageand
Current logo on the panel.
Charge Mode
Float
Environment:
Ambient temperature **0°C ~ *0
°C.
Relative humidity in used *0%
MAX.
Protection
Fixed voltage, current limited,
auto-feedback.
Fuse protected
Short-circuit protected.
Size
:
**0mm L *
**7mmW* *1.5mm H.
2.
OPERATION PROCEDURE
2.1 Make sure you are using the correct battery
charger.
2.2 Check for correct input voltage on the
batterycharger.
2.3 Connect power to lines N &
L.
2.4 The indicate LED marked
“CHARGELAMP” on the panel should be illuminated when switch power
on.The DC output voltage should be as follow:*3.8±0.2VDC or
*7.6±0.2VDC
2.5 With power off, connect output terminals “+/–
” to battery lead “+/– ”.
CAUTION !
Terminal lug must properly and securely crimp on
to wires and avoid shorted.
2.6 When Power is ON, The current will decrease
as the battery charges.
2.7 “0 A” indicates the battery is fully
charged.
2.8 Current limited circuits allow
engine crankingand running in parallel with the charge alternator
when needed.
2.*0
Voltage sensing circuit automatically shut offthe power when the
battery is fully charged.
