يبدو أنك لست عضوًا في TradeKey.com بعد. اشترك الآن للتواصل مع أكثر من 7 مليون مستورد ومصدر عالميًا.
انضم الآن ، مجانًا |
User تسجيل الدخول اشترك مجانا
Live Chat Live Chat
❯
BOOK A CALL
Book Call On Your Favorite Time

By Signing Up. I agree to TradeKey.com Terms of Use, Privacy Policy, IPR and receive emails related to our services

❯
Contact Us
F01994-Z1 KKMulticopter v5.5 Circuit board V2.3 + Programmer Firmware

F01994-Z1 KKMulticopter v5.5 Circuit board V2.3 + Programmer Firmware

FOB Price

أحصل على آخر سعر

( Negotiable )

|

Minimum Order

Place of Origin:

Guangdong China (Mainland

Price for Minimum Order:

-

Minimum Order Quantity:

1 Piece

Packaging Detail:

-

Delivery Time:

-

Supplying Ability:

1000 Piece per Month

Payment Type:

T/T, Western Union, PayPal

الاتصال الآن
FC MODEL

FC MODEL

China

عضو مجاني

الشخص الذي يمكن الاتصال به fc

zhenhua road, Shenzhen, Guangdong

الاتصال الآن

Description


This is the latest v.5.5 KKmulticontroller that has been factory made and fully populated. It uses the Murata piezoelectric gyros which have been incorporated into the board design for robustness. The Yaw gyro assembly is also slot mounted for extra robustness. These gyros have proven to be the most vibration resistant of all the gyros we have tested so far.
The board comes in black with a blue LED and has an on board In System Programming (ISP) header to enable easy firmware updates with a site recommended programmer. The on board Atmega**8 chip gives users the extra space to load expanded firmware with higher refresh rates to enhance stability.
The three adjustable potentiometers increase or decrease gyro gain for all three axis (Roll, Pitch and Yaw) and can be used to calibrate the ESCs and reverse the gyro directions if necessary during pre-flight setup.
The board also has six ESC/Servo headers which allow multicopter configurations from 2 to 6 rotors. There are also headers for thee aileron, elevator, throttle and rudder connections from your RC Receiver(RX). The board comes with a 4 x 3 pin jumper cables to connect your RX to the board quickly and easily.
There's variety offirmware available for this controller, you will haveload them due to your needs, only test program is loaded by default.
 
 
 

**0% brand new

Latest KKmulticopter controller V5.5 Board,V2.3 program

1.  Simple structure, Easy to Maintain and Debug Control

2.  Relying on potentiometer adjust gyro sensitivity.

3.  Full servo signal output, support normal ESC / analog servo

4.  Support for single-axis / UFO, Y3 *-axis, Y*-type *-axis, 4 axis, 6 axis, V*2  flight mode

5.  Supports *-axis "+" and "X" flight mode, support for six-axis "HEXA6" and "Y6"  flight mode.

 


 

Send a direct inquiry to this supplier

إلى:

fc < FC MODEL >

أريد أن أعرف:

Get Verified Buyers & Suppliers

Avail Free Consultation

By Signing up. I agree to TradeKey.com Terms of Use, Privacy Policy, IPR and receive emails related to our services

no thanks