Description
Film faced plywood
SPCIAFICATON
(1)Size
**5 x ***0mm, ***0 x ***0mm, ***0 x ***0mm or as
requested
(2)Thickness
Different thickness available, from 4mm to *1mm
(3)Core
poplar, birch, hardwood, combined or requested by
clients
(4)Glue WBP, MR
(5)Film Import dark brown film(Dynea or
Store-Enso)**0g/m2,
Chinese black film ******0g/m2
(6)Grade A/A grade or requested
(7)Packing Inner with plastic bag, outside with
3plywood,
then packed with sheet iron
(8)Application Concrete forming for construction
MOISTURE (***2%) & DENSITY
PRODUCTS
WEIGHT(KG/M3)
BIRCH
ABOUT **0
COMBINED
ABOUT **0
POPLAR
ABOUT **0
CONSERVE AND MAINTAIN:
HOW TO CUT THE BEST FROM OUR FILM FACED PLYWOOD
STORAGE
Always clean and repair the formwork panels before storage.
The formwork should then be stacked off the ground on level
supports and under cover. Framed formwork panels should be stacked
alternately face and back to back to avoid face damages by bolts
etc. If panels are wet, do not allow them to dry too rapidly.
SEALING OF EDGES
Phenolic fabric film faced plywood edges are fully sealed at
the factory and it is the most important that all edges remain
sealed. To obtain full value from a phenolic fabric film faced
sheet any recut edges should sealed as soon as possible with water
proof paint.
SEALING OF HOLES
Any holes made in fabric film faced formwork panels should
also be sealed to prevent water entering. If water does enter it
may cause swelling around the holes.
CLEANING AND REPAIR
To obtain full life, cleaning should be carried out
immediately after each use. Phenolic fabric film faced plywood may
be wiped with release agent or cleaned with water and stiffbrush .
It may be necessary to use a hard wood scraper but care should be
taken not to damage the plywood face. Do not use a wire brush or
sharp metal scraper to dislodge hardened concrete
