Description
The model, a pressure wheels adopt for cone. Make it ends and mode
disc and outer consistent line speed, and there were no wheel and
the dislocation of the mould friction, reduce the resistance and
reduce the kinetic energy consumption and prolong the service life
of the mould, this is with the similar compression molding
equipment of significant differences.
Second, the machine using screw center pressure regulating agency,
mould with big gap with small, suitable for different materials,
ensure suppression effect.
Three, the machine pressure wheels adopt body big slot width, and
the compression wear-resisting. The wood and straw compression
molding need a great deal of pressure, in the similar granulation,
press block, the great equipment, pressure wheel is the center of
the whole equipment component parts. "Cone round flat mode" is the
can be arbitrary increase pressure wheel advantage is not theory of
other equipment than, 〠such as ring model granulating machine by
ring die diameter limit, pressure wheel can't increase, lead to
pressure wheel bearings, the bearing assembly room becomes no
strong pressure ability, bearing damage cause equipment the
disadvantages of two three stop Hugh 】. One advantage: pressure
wheel increase, allow the bearing increase, enhance the ability to
withstand the pressure. Advantage two: pressure wheel increase, so
that the temperature of the friction produced extrusion is not easy
to transfer to bearing indoor, ensure bearing worked in low
temperature lubricating grease is not easy to overflow. Advantage
three: increased pressure wheel, can make the pressure wheel repair
**3 times and prolong the life, reducing production cost, increase
the project profit margins.
Four, the machine pressure wheels adopt more uniform, smooth
operation, but also increase the pressing area, improve the
production efficiency.
Five, the machine compression molding diversification, round rods
(Φ **-Φ *0 mm), diamonds (*0 "x *0 mm), particle (1.*-Φ *5 mm) as
long as the change of mould can do, to adapt to the different
material compression molding, to achieve the best results.
Six, granulating chamber has observed the door, always check
facilitate maintenance, repair. Application: mainly used in the
crude fiber granulation, such as: wood chips, rice, cotton pole,
MianZiPi, weed, etc. Various kinds of crops straw, living garbage
and waste plastic and factory waste, sticking rate is low, hard to
molding materials granulation, press block, the stick, also can be
used in biological JunFei, organic fertilizer, compound fertilizer
and so on low temperature granulation of wood particles machine,
sawdust granulating machine, machine wood, wood shavings system
stick machine
