Description

BMW EWS2, EWS3.2 EMULATOR
Support Type:E*4, E*6, E*8, E*9, E*6.

INSTALLATION:
1.  Remove original EWS2 control unit, find **2v ACC, GND, K-line wires, attach emulator. Emulator
    must be in service mode: JUMPER 1 shorted.
2.   Connect ANY K-line diagnostic adapter to vehicle diagnostic connector and launch EMULATOR
    CONFIGURATION UTILITY:                   
3.   Choose COM port, write in desired ISN number, press button Store. Or-
4.   For some ECU\'s it is possible to read ISN number directly from engine control unit. In this case
    select option "ECU xxxxx", press Read. Software will try to read ISN. If successful, choose option
    "EWS emulator" and press button Store to save ISN number into emulator.
5.   Disconnect emulator from K-line, remove JUMPER 1 and connect K output from emulator to
    DME(DDE)<一>EWS line.
6.   Don\'t forget to short two starter relay wires (EWS connector)!
7.   Car is ready to start.
In case of EWS3.2 similar procedure is used, only difference is that that it is NOT connected directly to
diagnostic K-fine.
There are NO any counters or car starts limited. You can change and store new ISN without any limitations.
Emulator is shipped with JUMPER 1 shorted. For testing purposes ISN ***9 is stored by default.