FOB Price
أحصل على آخر سعر( Negotiable )
|Minimum Order
Place of Origin:
China
Price for Minimum Order:
-
Minimum Order Quantity:
5 Set
Packaging Detail:
carton packing
Delivery Time:
-
Supplying Ability:
500 Set per Week
Payment Type:
Western Union, T/T
الشخص الذي يمكن الاتصال به Mr. Andrew
1 floor ,21#, 3 ditrict, Gong Da Tang, Jinhua, Zhejiang
This
machine contains five parts as
below:
A. Flatbed Printing Panel: It can
print various T shirts, pillows, shining board, porcelain board,
Pendants, metal key rings, mouse mat.
D. Cap Printing Panel: It can print various caps, such as sun cap, tour cap, cloth cap, eye patch, cloth pocket.
Att: the original time setting range **0~**0 degree, the Max temperature setting range **0~**0 degree.
The max baking temperature time setting range: 0~**9 seconds.
The machine has the function of temperature setting self-locking, so if the original temperature is **0 degree, the machine will control the max temperature range **0~**0 degree . Conversely, if the max temperature set **0 degree, then the machine will control the original temperature **0~**0 degree.
1. Heat transfer printing
Baking slowly: put the products into the mug press, press down the pressure handle, open the power, so the temperature will go up .When the temperature raise to the original setting temperature, the machine will send out short stridulation, press the execution key once ,till the machine send out dah (long voice). Press the execution key again to finish the heat printing. Take out the product, the temperature will come back the original temperature gradually.
Baking fastly: under the original temperature state, fix the object, press down the pressure handle,
press the execution key once, until the machine send out dah, press the execution key again , finish the
heat transfer printing . Take out the object, the temperature will come back to original
temperature.
2. The question prompt for the failure printing
A. the color is lighter: The temperature is too low, or the pressure is not even, or the time is too short .
B. the design is indistinct: the time is too long and lead to ink diffusing
C. the design has no luster: the pressure is too high or temperature too high.
D. part of design is indistinct: heat printing zone or the heating is not even.
E. Scar on the design: Heat printing time is too long.
F. dept of color is not the same: pressure not even or the coating is not even.
G. paper stick to the object: The temperature is too high, or the coating of the object is not good.