Sell Semi-Auto Solar Module Laminator

Description

Laminating Size: 2.2 X 2.2M
Power Supply: AC**0V 3 Phases 5 Lines;
Compressed Air Pressure: 0.6～0.8MPa;
Compressed Air Flux: ≥0.4M3/min;
Height of Vacuum Cavity: *5mm;
Temperature Uniformity: ±1.5℃
Temperature Accuracy: ±1.5℃
Temperature Range: Room Temperature to **0℃;
Laminating Time: 2～4min (Without Solidifying)
The Max .Vacuum: ＜**0Pa within *0s;
1. It adopts the integrated technology of Vacuum Cavity and Hearting Board to ensure the high vacuum degree and no deformation. 2. The Rubber of upper cover is non-toxic. And it adopts crumpled-resistance technology which may extend the lifetime of Rubber and improves the quality of solar modules. 3. The Rubber Sheet is fastened by many Fastness Clamps. This Characteristic may cut short time for replacing. 4. The Cover goes up and down pneumatically with non-pollution, non-leakage and no noise. 5. The Heating Station is independent so as to adjust easily and maintain conveniently. 6. The components of Vacuum Valve and Sensor in the Vacuum System are imported. They are high quality to ensure high degree of vacuum. 7. Cylinder self-lock: When the Upper Cover goes up to its right place the Cylinder will lock itself to prevent the Upper Cover from sliding. 8. Upper Cover self-lock: When the equipment is running, if it is power off unexpectedly the Upper Cover will not slide down.
 
  9. Emergency Operation System: The Emergency Buttons are set up in multiple locations. When the emergency occurs, the operator should press the button immediately to keep the equipment with original state of the same process. *0. There is low-level detection and alarming system in the heating transfer oil circulating system to prevent dangerous situation due to lack of oil. *1. The laminating sizescan be designed by clients.