Sell Anaerobic Retaining Compound

Description

Luoke Anaerobic Retaining Compound(LK**3/**9/**0/**8/**1/**8/**0/**0)

Luoke **0 seriesadhesive are used to fill the gap between cylindrical parts. By applying theseadhesives, a exact match similar to plastic with flexibility formed, and with different viscosity, flexibility and strength according to certain item.

�

LK**3

This adhesive hasoil-dissolved specialty, high strength. It is suitable for sealing and locking cylindrical parts, gap diameter of which is around 0.*3mm. It can be cured within ten minutes, to avoidwear from slight shock and corrosion of metal parts.

�

LK**9

With low viscosity and high strength, this adhesive is suitable for match of transition, over-rigidity orgap filling. It is suitablefor sealing and locking cylindrical parts, gap diameter of which is around 0.1mm. It can improve the strength ofpress fit and restore of wear holes � axis fitting parts or parts with error.

�

LK**0

With high temperature resistance, highviscosity and high strength, this adhesive can be used in injection movement sets, valve covers,cylinder liner, keyway and so on. It is suitable for locking and holding gapdiameter around 0.*2mm.

�

LK**8

With high strength,this holding adhesive is used to match and hold gap around 0.*5mm. It is suitable for status of kineticenergy loading or cyclic loading

�

LK**1

With medium strength, easy for disassemble, this adhesive is suitable forassemble of bearings. Recommended gap diameter is below 0.*0mm. It can cure in *0 minutes.

�

LK**8

High strength, it is suitable for statusof continuous operating temperature up to **0�C andgap diameter below 0.*0mm.

�

LK**0

With high strength and high viscosity(like paste), this adhesive is mainlyused for repairing, especially for press-fit parts such as bearings, keyway andend cover. It can fill gap diameter up to 0.*0mm.

�

LK**0

With high strength and medium viscosity, this adhesive is used for gapmatch or excessiveness. It is suitable for pulleys, bushings, gears, rotor andso on. It can repair the hole, shaft fitting parts and parts with error.Initial strength forms within *0 minutes, full strength in *4 hours. For steelit can bear *3N/Mpa of shear strength after full strength. It applies to gap around 0.*5mm.