Description

Repel-C may be applied from most cleaning equipment which is capable of producing foam either directly from a foam generator, or from gentle agitation of the diluted liquid which has been metered or pre-sprayed onto the carpet. Allow carpet to dry before vacuuming. Repel-C is not recommended for use with hot water extraction equipment.

1. Use any good quality, clean pressure sprayer, either electric or hand-operated. Stainless steel or plastic tanks are recommended to prevent rusting or staining. Use a Jet nozzle. Spray pressure should not exceed *0 psi. 

   Do not aerosolize or atomize this product. 

2. Hold the spray nozzle ****0 cm from the carpet, and apply half the prepared mix over the entire 

carpet area, spraying in one direction only. Then apply the other half over the entire carpet area, spraying in the opposite direction. 

3. To obtain the best performance from Repel-C, work the product into the carpet immediately after spraying.

   · Use a pile brush on pile-type construction.

   · Use a shag rake for open shag construction.

4. Allow the carpet to dry. The soil and stain protection of Repel-C will be fully effective as soon as the carpet is dry.

5. Use a damp cloth or sponge to wipe away spray from furniture or woodwork. Dried solid Repel-C usually can be removed by using a mild detergent solution.