Sell Polyamide 6, 66

TEST ITEMS

TEST METHOD AND CONDITIONS

TEST RESULTS

TEST METHOD

UNIT

CONDITIONS

(DRY)*3

Density

ISO***3

g/cm3

1.*8

Melt Volume Rate

ISO***3

cc/*0min

(**5)2.*6kg

5.4

Tensile Strength

ISO**7

MPa

*0mm/min

*9

Tensile strain at break

ISO**7

%

**7

Flexural Strength

ISO**8

MPa

*9

Flexural Modulus

ISO**8

MPa

1,**0

Charpy Notched

ISO**9

KJ/m2

2.9m/s*1J

*8

Izod Notched Impact

ISO**0

KJ/m2

3.5m/s*1J

*1

Flame resistance

UL**4

HB

Ash content

%

0

Processing Guidelines

Material Handling
Max. Water content: 0.*2%
Product is supplied in sealed containers and drying prior to molding is not required.

If drying becomes necessary, a dehumidifying or desiccant dryer operating at *0 °C

(**6 °F) is recommended. Drying time is dependent on moisture level, but **6 hours

is generally sufficient

Typical Profile
Melt Temperature ******0°C (******2 °F)
Mold Temperature ****0 °C (******4 °F)
Injection and Packing Pressure *****5 bar (*******0 psi)

Fill Rate
Fast fill rates are recommended to ensure uniform melt delivery to the cavity and prevent

premature freezing. Surface appearance is directly affected by injection rate