Useages: Â Mainly
used for mini solar fountain, equipment water cooling,
medical use, Aquarium / Fish Tank Circulation, etc.
Â
Can be amphibious, completely waterproof, soaking
or not is OK
Mute (Ultra Low Noise) *0dB
within *0cm
Surprisingly Powerful in so mini size
*3.6mm**8.8mm**8mm
Power Saving with just 3.7W at
*2Vdc
Eco-friendly material, for various
medical / home / industrial use
Can be used for High Temperature fluids
pumping when land use
There are ROSH/IP*8/CE/EMC
Certifictions of pump products.
Â
How to Choose pump:
1. Make sure the working voltage, current, head and flow. The Max
head means the static head. The pump can lift to the max heightwhen
there is no flow. If you want special flow at special height, you
must choose more higher head than the height you want to pump.
2. Make sure the dimension(threaded interface or not, the direction
and diameter of outlet and inlet).
3. Working environment(temperature and medium).
4. Other functional requirements, such as time control, motion
control, pressure control, flow control, and speed adjustment.
Â
NOTE when
using:
Â
1 Work at over-voltage is forbidden.
Voltage can be highly more than rated voltage for Battery with more
than 5AH at full capacity when there is no voltage-limitation
measure. Pls test the supply voltage before working if you are not
sure about it.
2 No direct AC Power
supply.Â
3 About the Max static head. Pump with 1.8m
head doesn\'t mean that it can spray as high as 1.8m when
connecting with power supply. The real mean of head is that the
vertical height of the water column in the plumbing. Spray head is
much lower than head.
4 Regulated power supply and switching
power supply are advised for more than 0.8A for a certain
margin.
5 Pump is not allowed to disassembly
unauthorized. Ceramic shaft and sleeve are precisely installed and
it\'s difficult for non-professionals to reassembly. We are not
responsible for quality problems caused by
this.
6 Ferromagnetic impurity and particles
should not be in pump for they affect magnetic actuator and bearing
friction. Pump should be promptly cleaned when transporting media
that is easy to crystallize or precipitate( Clean operation:
pumping clean water for 1min). Pls filter articles before inlet
when pumping fluids with solid particles.
Â
Â
Typical technical
features:
1 Brushless design, with the electronic
component commutation, no friction loss and high temperature caused
by brush friction.
2 High-performance and wear-resistant
ceramic shaft and ceramic sleeve. Sleeve and magnet have been
combined together through plastic injection. Long life span without
friction, as long as more than *0yrs without
maintence.
3 Stator and rotor are completely isolated
from each other, while stator and circuit board are potted by
epoxy. **0% waterproof and Amphibious use.
4 Rotor part with permanent magnet, pump
body with eco-friendly materials. Ultra-low noise(always lower than
*0dB), micro size, high efficiency and power
saving.
5 Pump parameters can be adjusted by stator
winding, eg. the max head of this pump can be from 0.7m to
1.8m, etc. Quite working voltage range.
6 Four suction cups in pump base. They can
also be removed as you wish.
