Description

HID compatible card reader
Introduction
HM***5 is designed with **5KHz FM modulation RFID card reader technology, it is HID compatible Proximity card reader. HM***5 reads all HID standard **5KHz proximity card serial number ( such as HID ***6 card, HID ***6 card and HID Prox II card and HID FOB tag etc ) and transmits HID proximity card number to the access control system using the common Wiegand interface, HM***5 can be with other OEM interface requirements in the future
Model Name: HOC-HM***5
Wiring:
Red: Power ***6V
Black: Power ground
Green: Wiegand output D0
White: Wiegand output D1
Brown: Green LED control
Blue: Buzzer control
Yellow: Hold
 
Specification
 

Dimension	*6**3**3mm
Power requirements	***6VDC at **0mA, A linear regulator is recommended
support card	All **5kHz HID proximity card, such as HID prox II, HID fob card etc
interface	Weigand
Reader range	5 - *0 cm
Frequency	******8KHz
Operation temperature	**0 C to **0 C
operation humidity	5%**5% relative humidity non-condensing
Audio/Visual Indication	Green & Red and Buzzer signal output
Response Time	Less than 0.2 seconds
cable length	**0mm
Weight	*0gram

LED/Buzzer function description
LED function: The LED color is normally in RED. It starts with 2 green flashes on power up HID compatible card reader HM***5 and remains RED. When a HID proximity card is present to the reader, The LED will momentarily flash green, this indicates that the proximity card was read properly by the reader. When the LED control signal is activated by access controller host, the LED changes to green.
Beeper Function: Power up the HID compatible card reader, the beeper will activate 2 times. When a HID proximity card is presented to the hid Proximity card reader, a short beep will be emitted. This indicates that the HID proximity card was read properly by the reader HM***5. When the Buzzer control signal is activate by access controller, the buzzer will sound till buzzer control line is released by the controller.
Hold function: when this line is activated by access controller HOST ,the reader will buffer one card read ( ignoring subsequent reads ) until the line is released.( high or released by access controller HOST).