Microcyber provides the PROFIBUS PA communication board customized as customer’s requirements. This solution can upgrade the traditional instrument to PROFIBUS PA instrument rapidly. The board supports bus communication, control and integration in fieldbus controller, stack, function block and interface circuit. Microcyber can assist customer in passing certification test of PNO and integration test with all kind of DCS system.

Software & Firmware Design and Development is including:

Hardware:

Support Atmel ARM7 series CPU

Discrete MAU

Flash ≥**6K

RAM ≥**8K

Support DPV0, DPV1 and PA Profile 3.*1

Support EEROM for data store

Support asynchrony serial interface, baud rate is changeable

Support common I/O port

Power supplier: 9 ~ *2 VDC

Supply power to customer board according to customer’s demand

Current consumption: ≤ *5mA

Supply to customer HW: 3V, *0mA or 5V, 6mA

Support two kind of communication controller

Smar FB***0

Microcyber FBC***9

Intrinsically safety: HW has passed FISCO

EMC compliance

Software:

Support function block AI,AO,DI,DO and TOT

Customized transducer blocks

EDD File: compliant with SIMATIC PDM 6.0

Technical Service:

Certification Pre-Test

Microcyber provides Certification Pre-Test environment. The Certification Test is done for the field device at Microcyber prior to the PNO official Certification Test. Microcyber explains the results and helps to analyze the errors.

The success of the Certification Pre-Test shows the PNO official Certification Test will be passed.

Main technical support:

PROFIBUS PA expert guidance

Minimized certification period

Use of official test tools

PNO Certification test support

Microcyber provides customers technical support for the PNO Certification Test at the Test Lab in the world. As part of completed services, Microcyber is supporting:

PROFIBUS PA professional guidance

Request for test offer from Test Lab

Test order at Test Lab

Error analysis

General Conditions:

There is no a stack license fee.

There is no an annual support fee in first year. Microcyber will provide customer new revision if there are upgrades or modifications to firmware.

Customer should provide a product sample to be used by Microcyber for software development. Microcyber should have the product sample within three weeks after the software development agreement is signed.