Description

Production Description
Double Layer Roll Forming Machine for E*4 & Sinusoidal which exported to
El Salvador
Main Equipment
1. Two (5*1) Ton X ***0 Hydraulic Expand Uncoiler with Coil Car
     *-Hydraulic system to expand coil inner hole
     *-Support arm equipped at the end of the main shaft
     *- Taper wedge expand type
*-Self-contained electric controller, out of control system of the complete line
*- Double roller Chain and Pinion
*- Coil car can move up/down and forward/backward
  2.Entry Bench
*- Un-powered, Height Adjustable
  3. Manual pre-shearing Device
*- un-powered, dual Levelling
  4.Polythene Film-On Device for Profile E*4, Aluminum Material
*-Un-powered, with un-coil-rollers at double sides
*- With rubber shaft to film-on the film
  5. Double Layer Roll Forming Machine
     *- Gear/Sprocket driving; Dual Levelling
     *- Upper Level for E*4 profile, **-step to form
*- Lower Level forSinusoidalprofile, **-step to form
*- Two encoders, one for upper level, the other for lower level
*- The two levels can not be run at the same time
*-Manual Clutch to switch the driven system
*-Forming speed: Approx. *2m/min
*- Protection Mesh Cover (full mesh type) Above Roll-former To Avoid Hands Go Inside
  6. Hydraulic Cutting Device
     *- Stop to cut, Post cut, No blanking cut
     *-Two pairs of cutting tools
     *-Equipped with the lubrication cover in the moving parts of the cutting press.
7. PLC Control System
   *- Control the quantity and cutting length automatically.
   *- Control the switch action to run the different two profiles
   *- Combined with: PLC, Touch Screen, Inverter (Siemens), Encoder (Omron), etc
*- Cut-to-length tolerance≤±2 mm
8. S**0 Inkjet Printer including encoder holder and printer table
9. Product rack     
*- Un-powered, Height Adjustable