hydraulic oil press

Description

Shandong Source machinery Co., LTD. 6 YY oil press is suitable for high oil content crops likes peanut, soybean, rapeseed, walnut, almond. With high technology content, reasonable design, strong and durable, and the characteristics of high efficiency and energy saving, compared with the early product has stable performance, easy to operate, durable, good product quality. The comprehensive utilization of bread of high protein content, range, etc.



     6 YY type hydraulic oil press is the simplest, mechanical operation in the oil yield efficiency is higher, the replacement of wearing parts, less of a building area of less an oil mill, this machine is mainly oil-bearing crops object for processing: peanut, soybean, rapeseed, walnut, pine seed peel (best), tea seed, sunflower seed oil crops, etc.



This machine is in accordance with the principle of hydrostatic pressure transmission, hydraulic oil as pressure transmission medium, extrusion and then the oil will oil squeeze out. It is a closed loop system composed of two parts: the hydraulic system and oil press.



 



Performance and characteristics.



1. This machine is small volume, less coverage, easy to learn, understand and less operation with low power consumption.



 2. Frame type, hydraulic unit installed outside.



It is hydraulic machinery with high pressure, efficient oil output, incense oil full-bodied, clean and high quality, etc.



 4. Not only manufacture all sorts of plants oil, but also meat oil, clay, de-oiling, dehydration, degrease all kinds of chemical raw materials.



 5. This oil press except for all kinds of vegetable oil press can also squeeze of animal oil press, clay, of , dewatering, juice, etc.



The rules of operating:



1. Note: Before start



 (1) Clean inside the tank and clean the hydraulic oil.



 (2) Check whether each part bolt is loose.



 (3) The *5 reversing switch power supplied by the on-board stop switch, the other three core wires side connected to the motor, the motor need to check the rotary direction.



 2, Extraction process:



(1) No load running for 1 to 2 minutes first, such as in winter and spring, empty ***0 minutes, make the oil diluted and ease of operation.



 (2) Exhaust fume from fried materials, separate materials by plates and put to feed bucket, keep oil surface is slightly lower than expected on the bucket; otherwise, the oil cylinder will over travel. Push overall press under the oil pan, cylinder alignment press oil pan, then switch on. (3)Pull out explorers to the valve and switch on the power switch, pressure bearing oil pan. (Cylinder telescopic by manual reversing valve, namely when the stem to open, press will do downward movement and vice-versa)



 (4) Only expert handlers allowed, Forbidden leave away while the host is d in the process of booster, the main motor must stops working when the pressure gauge reaches *0 million, otherwise it will damage the hydraulic system.



 (5) Start motor again after pressure gauge callback, turn off the power supply if point to *0 MPa again, keep it stable to *0 MPa, If material barrel oil finally no oil come put means oil has drained.



 (6)Lift pressure oil pan, hang hook at one end, the other side on the VAT, and press pressure oil pan, lift charging barrel, pull out the oil cake.



 (7)Hold up oil pan, remove hook then prepare for the second press.