Description

Features of tile:

1.Conductivity

●It satisfies the electric resistance requirement of UL **9 & NFPA *9.

●Surface electric resistance: ******6Ω

●Static decay time:5,**0lts to zero 0.*3sec.

2.Durability

●Excellent anti-wear,anti-water,and anti-chemical properties.

3.Uniform gauge and color maintenance

4.Anti-load property

●There is no problem with machine movement,carrier vehicles or beds.

5.Permanent conductivity

●Conductive material is distributed evenly in entire tile so that it has permanent conductivity.

6.Non-flammable.



WARRANTY:

HUATONG CO,.Ltd.  warrants, for a period of one year after purchase, that its products are free from defects in materials and workmanship,and further 
warrants,for  period of five years after installation that when installed and 
maintained in accordance with procedures recommended by HUATONG CO,. Ltd



THESE WARRANTIES DO NOT COVER: 

(1）workmanship of installation

(2) dissatisfaction,problems or damage due to installation or maintenance other 
than as recommended By HUATONG CO,. Available from your dealer or by writing 
HUATONG CO,. Lte.,Customer Services Team.);

(3)Ltd.(Recommended installation and maintenance instructions are reduction in 
gloss from use; 

(4)damage due to accidents,gouges,scuffs,scratches or indentations; 

(5)dissatisfaction,problems or damage due to irregularities caused by 
subfloor,including but not limited to moisture,alkali or hydrostatic,pressure in 
subfloor.

THESE WARRANTIES ARE EXPRESSLY IN LIEU OF ANY OTHER WARRANTIES,EXPRESS OR 
IMPLIED,INCLUDING BUT NOT LIMITED TO,ANY IMPLIED WARRANTY OF MERCHANTABILITY OR 
FITNESS FOR A PARTICULAR PURPOSE.


INSTALLATION:

HUATONG Conductive tile and Static-Dissipative tile should be installed on sub 
floors that are leveled ,smooth and free of cracks.Residual humidity should be 
under 2.5% tested with the CM Dumb test.Tiles,adhesive and installation site should reach a temperature of at least *8 at least *4 hours before installation.Not necessary is to apply copper strip on subfloor use a good quality conductive adhesive under **5 Ohmto glue the tiles.Welding is only recommended in wet areas,cleanroom application and Operating theatres.For further details on installation methods ,please ask us.



CARE AND MAINTENANCE:

Due to its non-porous surface HUATONG Conductive tile and Static-Dissipative tile 
has a surface from which soil and grime can be removed.As with any floor,lighter 
colors show soil more readily than darker colors and therefore require more 
frequent and thorough cleaning.

Clean floor by machine-scrubbing with a good neutral detergent,followed by clear 
water rinsing.Lightly soiled floors may be damp mopped but also should be 
periodically Hmachine,synthetic stripping pad and a commercial stripping 
solution.Clear water rinsing is necessary after any scrubbing or stripping 
operation to remove all cleaner residue.

Flooring should be maintained by spray-buffing.This procedure produces a moderate 
to high gloss and provides additional protection from marking and scuffing.
Waxes or floor finishes should NOT be used on HUATONG Conductive tile and Static-
Dissipative tile except in a spray-buffing procedure.The regular appilcation of a 
wax or floor finish will build up an insulating film on the floor.

If a high-gloss wet lookis desired,it is advisable to use a high speed burning 
machine(**0RPM`s or more).
For detailed information ,please ask us.




QUALITY CONTROL/TECHNICAL ASSISTANCE:

1)Test for conductivity throughout various stages of production and before being 
released.

2)Test each batch of conductive adhesive for electrical resistance before shipment.

3)HUATONG CO.,LTD sales representative are available to provide technical 
assistance in evaluation of on site installation conditions or to review actual 
installation techniques.