Description
Description:
Advanced Commercial Food Dehydrator - AirFlow - **0, **0 square
foot of tray drying area can hold approximately **0 lbs. of beef
sliced at 1/4" thick to make beef jerky. The AirFlow***0 can also
dehydrate fish, vegetables, and fruit. The proper safe way to
dehydrate beef is to raise the temperature of the beef in a closed
chamber like our AirFlow***0, set your temperature controller to
**0 to **0 depending on your process temperature, close the damper,
go through your (lethality step or cook time) with full humidity
this step is done before any dehydration takes place. Then once you
go through this lethality step open the damper go to the
dehydration step, our machine can easily do this. How it works, our
machine has 1 circulation fan that circulates the air many times
through the trays while the exhaust fan vents the moist air out of
the building. With 1 powerful *9,**0 watt heater, you can process
your batch much more quickly saving time and money.
Features:
Commercial/industrial Digital Temperature
Controller saves energy by cycling the heaters on and off once your
set temperature has been reached, the operating temperature can be
set from **0F to **5F.
Digital timer will turn the machine off at your
set time.
1 *9,***-watt heating element, for a faster
process (lethality cycle or cook time) and dehydration time.
Heavy Duty solid state relays.
1 Heavy Duty 1 HP premium *5.5% efficient
electric motor, with extra-large ball bearings for long service
life.
1 heavy duty exhaust fan with an energy
efficient EC motor is **0% speed controllable.
1 Potentiometer that controls the speed of the
exhaust fan.
1 Electric Damper, closes so no moisture will
escape during the lethality cycle, opens during dehydration
cycle.
Precision ground drive shaft for smooth
operation.
Heavy Duty Stainless Steel ball bearing with
food-grade grease.
All stainless steel bolts and screws.
Heavy Duty stainless steel hinges.
Heavy Duty stainless steel latches.
2 Heavy duty NSF racks can be easily rolled in
and out of the Dehydrator for easy loading and un-loading and
cleaning 1.5" spacing between each tray or grille.
*0 Heavy Duty stainless steel wire grilles,
grilles measure, *8" x *6" 3.*5 square feet per grille, **0 square
feet of total drying area.
Heavy Duty ***1 T6 aluminum frame with welded
joints.
.**0 thick heavy duty aluminum on the exterior
of Dehydrator.
.**0 thick aluminum on the interior of the
Dehydrator.
Floor Heavy duty ***1 aluminum frame with welded
joints, welded to a 3/*6 thick Heavy Duty Aluminum floor.
Floor insulation: 2 of polyisocyanurate
insulation.
Wall insulation: 2 of polyisocyanurate
insulation.
Ceiling insulation: 2 of polyisocyanurate
insulation.
Stainless Steel hinges, latch and hardware.
Approximate size: *6" long x *1" wide x *0 high,
approximately weight ***0 ***0 pounds.
Requires a **8 **0 **0 or **0 Volt 3 phase, *0
Amp circuit.
Please allow approximately *2 weeks to
manufacture.