1. Weight

unbroken plastic 4MM board 4.**5KG/m2

Ordinary plastic 4MM board **6.3KG/m2

 

2. Flexibility

One-way continuous plastic: strips with a width of *0 mm transversely; strips with a longitudinal cut width of *0 mm; **0 folds back and forth. Aluminum splits One of the plastic cores continues.

Ordinary plastic: Strips with a transverse cut width of *0 mm; strips with a longitudinal cut width of *0 mm; **0 folds back and forth. Aluminum splits Two plastic cores are broken.

 

3. Processing

Ordinary plastic: The main component is LDPE, high-pressure low-density polyethylene. Can be slotted and bent, the general aluminum-plastic panel installation is no problem, the building with the not too high floor can use this plastic, there is no problem, just the slot is bent into *0 degrees, no need to bend into an arc, General plastic can be done, as shown below:

Unilateral continuous plastic: the main component is LDPE, high-pressure low-density polyethylene. If the cylindrical shape like this needs to be wrapped with aluminum-plastic plate, then it should be made of plastic continuously. The radius of the arc is more than **0mm. All plastics can be used. If it is less than **0mm, especially less than **0mm and **0mm. The radius must be constant plastic. Constant plastic performance is better, the strength of the board, the adhesion of aluminum to plastic, the surface effect of the aluminum-plastic board, will be better.

 

4. Board Surface

The aluminum-plastic composite panel made of one-way continuous plastic is very small if the aluminum skin is very thin 0.*4mm*0.*8mm.

If the surface of the ordinary plastic is 0.*1MM, it will not affect the defects of the door.

 

5. Characteristics

1) Excellent fireproof property

2) Super peeling strength

3) Perfect cold resistance performance

4) Excellent surface flatness and smoothness

5) Superior weather, corrosion, pollutant resistance

6) Even coating, various colors

7) Superior impact resistance

8) Lightweight and easy to process

9) Easy to maintain