Non-Toxic Translucent Clear Liquid Silicone Rubber Mold Making Silicone-Mixing

الوصف

Warm Tips :
As addition cure silicone is a kind of platinum cure system, which will be easy to cause uncured problem ,so pls kindly follow the tips as below :
 
Do not mix with liquid condensation silicone rubber or even the tool which used for condensation silicone rubber.
Do not mix with organic matter which contains N, S, P organics and ionic compound like Sn, As,Hg, Ph. (Do not smoke when you use this addition silicone rubber)
Do not add any pigment or powder into the addition cure silicone rubber without any testing to prevent uncured problem.

Description
 
DC-A15 is a kind of two part silicone rubber in addition cure or platinum cure type with mixing ratio of 1:1 or *0:1.It can cure at room temperature as well as under heat. Its a kind of food grade silicone which has got the United States FDA certification. And mainly used for mold making.

Application

DC-A15 silicone Rubber is mainly used for making molds of concrete stone,GRC,polyurethane products ; wax, candle decoration; rapid prototyping and tire molds; chocolate, candy and similar products molding.

Characteristics
An exceptional fluidity and good operability, easy to demold
Aging resistance, high temperature resistance (**0℃***0℃)
Environmentally, food-grade, FDA Certification.
Good tensile and tear strength
Outstanding bubble releasing
Very Low shrinkage
Non-deformation

Operation Instructions
Step 1: prepare the original molds 
Prepare an perfect original mold and clean it totally before operation.
Notes: Make sure your original molds and operation tool were cleaned up totally to avoid uncured problem .
 
Step 2: Take **0 G part A and **0 G part B (Or **0 G part A and *0 G part B) and mix them evenly.
Notes: Addition cure mold making silicon rubber is two parts flowing liquid, Pls follow the step strictly:
1.Weigh the two part exactly by electronic weight. If any part not in exactly weight, it may cause changing of hardness, or even cause uncured problem.

2.Mix part A and part B evenly. Otherwise the silicon rubber will be partly solidified and this will give birth to difficulties in your final operation. Whats more, the finished molds will meet a short life. All of these will cause a waste of silicone rubber.
 
Step 3: Vacuum pumping
Without exception, this step takes less than *0 minutes. Otherwise, it will cause cross linking reaction, and no more further steps will be available.
 
Step 4: Pouring casting or Brush operation
Notes:1. For simple pattern products we suggest use pouring operation way, which will be very easy to operate and demould. Pourable silicone require low viscosity which will be easy to flow smoothly and easy to de-air .
        2.For delicate pattern products we suggest use brushing operation way, which can copy the pattern exactly. Brushable silicone require high viscosity which wont be easy to flow away and easy to brush .  
        3. We suggest to set the silicone mold for another *2 hours after demould before you put it into a large production .
 
Technical Parameters