الوصف

Silicone Rubber Electric Conductive Coating
PD******4
PD******4 is two components compound electronic conductive spraying coating. Characterized
by stable resistance value, strong adhesion, wear-resisting, glossy surface, tearing resistance and
other advantages.
Mainly applied to silicone rubber Connector, intermediate, lightning arrester and other silicone
rubber electric cable accessories.
Electronic Resistivity Rth:1KΩ ~3KΩ. (Space between measuring point＝*0mm)
Application Method:
Process
Condition
Spraying viscosity
(Iwata 2# cup,
*5 ℃ ) (S)
Spraying
distance
(cm)
Spraying
caliber
mm
Spraying
pressure
Mpa
Force Drying
(******0℃)
Min
Coating ***0 ****5 1.0/1.5 0.**0.3 ***0 (dry to touch)
****0 (hard dry)
1. Application Ratio：A: B=**0 : 1 (A is coating ink, B is catalyst)
2. Pleases do stir evenly and filter with **0~***-hole mesh **0～**0. Curing the ink after
spraying *0 minutes later.
3. The activity life of mixed ink is 8 hours.
4. Keeping constant temperature at *2℃and constant humidity when using conductive coating.
5. Please do make backflow of spraying gun every *5 minutes or mixing during continuous
operation for keeping the uniformity of coating and avoiding nonuniformity of electrical
resistance.
6. As the electric cable accessories relate to various shapes, if conditions allow, take the way of
hoisting automatic spraying or twice spraying would be better for resistance value when
coating on the silicone rubber electric cable accessories.
Note: Before first baking spraying **2 times or spraying over 8 areas, then spraying over 8
areas and curing again..
7. All the above data only for reference.
Curing Condition:
A.Vertical oven:Baking at **0℃ for *0minutes.
B.Horizontal oven:Baking at **0℃ for *0 minutes.
Attentions：
1. This agent including volatile solvent, please keep ventilating and far away from heat and open
flame.
2. Avoid skin contact for a long time and vapor inhalation, if happens,washing with soap once
skin contact.
3. The operating environment is important for coating process, please work in dust-free plant at
constant temperature *5～*5℃ and constant humidity at *5～*0%.
4. During the operating process, more dust pollution and more NG products, as the changing of
temperature and humidity, bad property of flowability and adhesion strength will be appeared by
low temperature, and the higher humidity will cause coating shrinkage cavity, the lower humidity
will cause potential safety hazard and whity by static.
Storage: Stored at room temperature for 6 months without mixing.This products has sediments
belong to the normal situation. Please shake well before using.
Packing: 1KG/Bottle