الوصف

Generator Controller: Diesel Generator Controller: HGM**0 is an Automatic Engine Control Module. The module is used to automatically start and stop the engine, indicating the operational status and fault conditions, automatically shutting down the engine and indicating the engine failure by LED on the front panel. Operation of the module is via a three position key switch mounted on the front panel with OFF(O), STARTand AUTO positions. In the ‘O’ position the output are de-energized. Manual Operation: 1. Select manual run 2. Depress pre-heat for required length of time 3. Press START to crank engineOnce the Start is pressed and maintained, the engine fuel system is energized. The ‘Crank’ output is then energized and the starter motor operated, disengaging automatically when the engine fires or when the ‘Start’ is released. The protection hold-off timer is then initiated. Automatic Operation: 1. Select AUTO 2. When Remote Startis active, the generator will automatic ***** of any of the following alarms (which are close on fault) will cause the run output to de-energize. Low Oil Pressure. High Engine Temperature.Auxiliary ShutdownOver speedThis will remove the fuel supply from the engine and bring it to rest. Each alarm has its own LED indicator and once activated no further alarm conditions will be accepted. The alarm output and relevant LED will remain active until the unit is reset by turning the switch to the ‘O’ position. Specification DC Supply:8 to *5 V Continuous. Alternator Input Range:*5 - **6VAC(**0%) RMS Alternator Input Frequency:*0 - *0 Hz at rated engine ***** speed: nominal frequency **4% (**4% Overshoot) Start Output:Solid State 1.2A negative grounding terminal Fuel Output:Solid State 1.2A negative grounding terminal Pre-heat Output:Solid State1.2A negative grounding terminal Operating Temperature Range:**0 to **0°C